Bikeman Performance
Polaris RZR Pro R Stage 3 Performance Kit
Heat Shield Color:
Heat Shield Color
Backing Plate Color:
Backing Plate Color
Helix:
Helix
Quantity:
Features:
-
.430 LIFT DROP IN CAMS
-
Bikeman CUSTOM SPEC FROM BRIAN CROWER
-
INSTANT THROTTLE RESPONSE
-
LOW END GRUNT AND TOP END PULL WITH THE CAMS
-
CHOPPY IDLE PEOPLE WILL TURN HEADS OVER
-
OUR PERFORMANCE CLUTCH SPRINGS HOLD MUCH BETTER BELT TENSION THEN FACTORY. CLUTCHING ADJUSTS TO ANY TERRAIN
-
MORE RESPONSIVE FEEL
-
CYCLONE CLUTCH COVER FOR EVEN COOLER BELT TEMPS AND LONGER BELT AND CLUTCH LIFE
-
GAINS TOP SPEED AND LOW END POWER
-
THESE CAMS ARE SPECIFIC TO US AND NONE ELSE CAN BUY THIS SAME CAM PROFILE. BRAND NEW CORES NOT A REGRIND CAMSHAFT
- MUST SEND IN ECU FOR HARD FLASH
- SLIP ON EXHAUST free flow exhaust
- SNYPR WEIGHTS with springs
- Cyclone Clutch Cover
- ECU HARD FLASH
- Custom .430 Lift Cams
Steps for starting your Pro R stage 3 and above for the first time.
- Roll the engine over by hand at least 10 revolutions clockwise when looking at it from the rear.
- Check Cam timing to make sure it is correct
- Make sure coolant and oil is at the correct level.
- Start the engine and hold above 2000rpm until it reaches 170 degrees F.
- Using the throttle drop rpm 50 rpm per 30 seconds until idle seems unstable.
- Stay at the unstable rpm until it becomes stable and then repeat step 5.
- Once the machine is idling at 1450 stable with no throttle input let sit and idle for 10-15 minutes.
- Your machine is now ready to ride.
- On higher duration cams it is common to need to give a little throttle to start the vehicle this is completely normal.
Pro R HP ratings: Stock 230-235hp@8400rpm
Stage 3: Level 3 ECU tune, BMP .430 lift cams and BMP slip on muffler 298hp@8775rpm / 194TQ@7525
NOTE: ONCE WE RECIEVE YOUR ECU, WE WILL FLASH THE TUNE AND SHIP BACK EVERYTHING AT ONCE. PLEASE CALL IF YOU WOULD LIKE PARTS SENT SOONER. Sending in your ECU/ECM? Fill out this Work Order Forum and put it inside your package
VEHICLE FITMENT
Polaris RZR Pro R