Polaris RZR Pro R Stage 3 Performance Kit

Features:

• .430 LIFT  DROP IN CAMS
  
• Bikeman CUSTOM SPEC FROM BRIAN CROWER
  
• INSTANT THROTTLE RESPONSE
  
• LOW END GRUNT AND TOP END PULL WITH THE CAMS
  
• CHOPPY IDLE PEOPLE WILL TURN HEADS OVER 
  
• OUR PERFORMANCE CLUTCH SPRINGS HOLD MUCH BETTER BELT TENSION THEN FACTORY. CLUTCHING ADJUSTS TO ANY TERRAIN 
  
• MORE RESPONSIVE FEEL
  
• CYCLONE CLUTCH COVER FOR EVEN COOLER BELT TEMPS AND LONGER BELT AND CLUTCH LIFE  
  
• GAINS TOP SPEED AND LOW END POWER
  
• THESE CAMS ARE SPECIFIC TO US AND NONE ELSE CAN BUY THIS SAME CAM PROFILE. BRAND NEW CORES NOT A REGRIND CAMSHAFT
  
• MUST SEND IN ECU FOR HARD FLASH

• SLIP ON EXHAUST free flow exhaust
• SNYPR WEIGHTS with springs
• Cyclone Clutch Cover
• ECU HARD FLASH
• Custom .430 Lift Cams

Steps for starting your Pro R stage 3 and above for the first time.

1. Roll the engine over by hand at least 10 revolutions clockwise when looking at it from the rear.
2. Check Cam timing to make sure it is correct
3. Make sure coolant and oil is at the correct level.
4. Start the engine and hold above 2000rpm until it reaches 170 degrees F.
5. Using the throttle drop rpm 50 rpm per 30 seconds until idle seems unstable. 
6. Stay at the unstable rpm until it becomes stable and then repeat step 5.
7. Once the machine is idling at 1450 stable with no throttle input let sit and idle for 10-15 minutes.
8. Your machine is now ready to ride.
9. On higher duration cams it is common to need to give a little throttle to start the vehicle this is completely normal.

Pro R HP ratings: Stock 230-235hp@8400rpm

Stage 3: Level 3 ECU tune, BMP .430 lift cams and BMP slip on muffler 298hp@8775rpm / 194TQ@7525

VEHICLE FITMENT

Polaris RZR Pro R

INSTALLATION